Milling unit for a circular cutter with a maximum diameter of 15 mm. Cycle time
 ApplicationThis unit is intended to be used with small diameter circular cutters where machining takes place in the immediate vicinity of the guide bush. The unit is fed in front of the guide bush towards the two axes x and z, so that it is very close to the bar undergoing machining, thereby generating minimum overhang. This also guarantees exceptionally good strength.This unit was specially designed to mill the axis hooks of drums on the DECO 7 and 10. It is, therefore, fully adapted to the execution of extremely small, precision parts, as used in horology. The milling operations are contouring. The unit can be used to make components such as cams parts without problem. CommentThis unit has a fine axial setting, so that the tool position in z (axial) can be more refined.The design of this unit is very similar to a polygon system. It acts in exactly the same way as the latter, without encroaching on another position.
THINK PARTS THINK TORNOS ascl.com | |||||||||||||||||||
|
|
 |
 |
|
|
TORNOS SA Rue Industrielle 111 CH-2740 Moutier Switzerland |
Tel.: +41 (0)32 494-4444 Fax: +41 (0)32 494-4903 www.tornos.com |
|