Adaptation for collet F25 (No. 76-64) for the DECO 26a counter-spindle Max. diameter: 26 mm
ApplicationThe system for clamping the collet in the counter-spindle has changed to a new standard. A nut has replaced the bayonet system. The main spindle has always been equipped with the nut system and been fully satisfactory. With this development, both spindles have now the same universal system.Consequently, clamping is becoming more and more universal. The use of a nut eliminates any doubt about positioning - once the nut has been tightened, clamping is guaranteed. This system also increases the clamp bearing surface of the collet and hence the strength of the assembly. As positioning is ensured by a simple screw operation, repetition is ensured. CommentThese two new options replace options 4020 and 4030 "bayonet clamping". The collets and guide pins are absolutely identical to those used in the old versions of counter-spindle where clamping was by way of the bayonet system.
THINK PARTS THINK TORNOS ascl.com |
|
|
 |
 |
|
|
TORNOS SA Rue Industrielle 111 CH-2740 Moutier Switzerland |
Tel.: +41 (0)32 494-4444 Fax: +41 (0)32 494-4903 www.tornos.com |
|