Principle of the "bar pusher"This system requires a bar feeder which pushes the part through the guide bush to the retractable stop. This principle is not compatible with the Robobar SSF 107. The part is pushed right to the stop which then retracts. The clamp (which is controlled by a second actuator) holds the part ready for removal.
 The maximum part length is 200 mm, and based on the principle of one bar pusher only, the maximum machinability is 2 x 60 mm (headstock travel), meaning that long parts worked at both ends can be achieved, a typical example being an engine axle.
 This low cost device can execute long parts on a 5 axes machine (without the need for a counter-spindle to "draw the part", which is a financial and technical alternative).
Advantages :
THINK PARTS THINK TORNOS ascl.com | |||||||||||||||||||||
|
|
 |
 |
|
|
TORNOS SA Rue Industrielle 111 CH-2740 Moutier Switzerland |
Tel.: +41 (0)32 494-4444 Fax: +41 (0)32 494-4903 www.tornos.com |
|